Advertisement
I. Overview
The KANE-PU690V proving unit is a
compact & lightweight voltage proving
unit designed for the compliance safety
checking of 2 pole voltage testers prior to
testing on a live circuit.
It is a requirement of the Electrical Safety
Council and the HSE that every Electrician
proves their voltage testers before & after
confirming safe isolation. The KANE-
PU690V is also high & low Z impedance
compatible for proving voltage on
mulimeters.
II. Safety Notices
1. Please carefully read & fully understand
the warnings & operating instructions
before use. If the instrument is used
in a manner not specified by the
manufacturer, the protection provided by
the instrument may be impaired.
2. If the proving unit appears damaged or
is not working properly, stop using it
immediately.
The operator's safety is no longer
ensured, the instrument is to be put
out of service & protected against use.
Safety may be compromised if the
instrument:
● Shows obvious damage.
● Does not carry out the desired
measurements.
● Has been stored for too long under
unfavourable conditions.
● Has been subjected to mechanical stress
during transport.
3. Once the indicators on the voltage tester
have been visualised, please remove the
test probe from the right input first, &
then from the left.
3
II. Safety Notices (continued)
4. Do not operate the proving unit for
periods longer than 10 seconds.
3. Clean the tester casing with a damp cloth
& mild detergent. Do not use abrasives
or solvents!
4. When low battery indication appears,
please replace the batteries.
5. Comply with local & national safety
6. The proving unit may not output voltage if
the unit is used outside of the operating
specifications (see technical specification
for details).
III. Instrument & Manual Symbols
Symbols displayed on the instrument &
in the instruction manual:
Warning! Warns of potential danger,
& to comply with the instruction
manual.
Caution! Dangerous voltage,
potential risk of electrical shock.
Equipment protected throughout by
double or reinforced insulation.
Conformity symbol, the instrument
complies with the relevant
directives. It complies with EMC
Directive (2014/30/EU),
Standards EN 61326-2-2. It also
complies with the Low Voltage
Directive (2014/35/EU), Standards
EN 61010-1, EN 61010-2-030 &
EN61326-1 are fulfilled.
4
Advertisement
