Preparation 1: Preparing The Receiver And The Remote Control - Sony STR-AZ3000ES Startup Manual

Preparation 1: Preparing the receiver and the
remote control
Before starting the following steps, connect speakers and AV devices
to the receiver referring to the supplied Startup Guide.
1
Insert batteries into the remote control with correct polarity.
2
Assemble the calibration mic stand.
 Insert the mic stand pillar all the way into the mic stand
bottom.
 Insert the mic stand top all the way into the mic stand pillar.
R03 (size AAA) batteries
Mic stand pillar
Mic stand bottom
Mic stand top
Mic stand pillar
3
Place the mic stand at your listening position and set the
calibration microphone on the mic stand.
The calibration microphone is used for setting the speakers
(Auto Calibration) in "Preparation 2: Performing Easy Setup"
(page 23).
Adjust the position of the mic stand so that the calibration
microphone is level with your ears.
Calibration needs to be performed twice. For the second
microphone position, follow the on-screen instructions in Easy
Setup.
Notes
• Fully insert the plug of the calibration microphone into the
CALIBRATION MIC jack. If the calibration microphone is not firmly
connected, it may not be possible to measure correctly.
• Install the calibration microphone horizontally so that L (left) and R
(right) are at the same height.
continued
21
EN