Basket Alignment - Continental Girbau L36USS36G Owner's Manual

BASKET ALIGNMENT—

SINGLE MOTOR
MODEL
Basket Alignment—Single Motor Model
Step 1 Loosen both eccentric locking collars on the two basket bearings
(flange and pillow block types). Loosen the set screws and turn
clockwise. If necessary, use a punch and mallet, striking the
punch hole in a clockwise direction to break it loose.
Step 2 Loosen the 4 side bolts, "1, 2, 3, 4," on the basket bearing
bracket. (see figure 3) Loosen the two adjusting bolts and
locknuts "5, 6," inside the bracket. And loosen the bolts "7," on
the pillow block bearing.
Step 3 Place one "A" and two "B" diameter pins inside the drying
compartment between the rim of the basket opening and the rim
of the door opening in the positions shown in figures 1 and 2.
Check the two "B" pins for equal clearance.
NOTE
Push the basket toward the rear.
Step 4 With the pins in position, lock the collar nearest the rear wall of
the dryer on the shaft by striking the punch hole in a
counterclockwise direction. Tighten the set screw.
Step 5 Tighten the side bolts "1, 2, 3, 4," in numerical order. Tighten
the bolts "7" on the pillow block bearing. And tighten the bolts
"5" and locknuts "6".
Step 6 Remove the aligning pins and if alignment is okay, then tighten
the collar on the pillow block bearing the same as in Step 4.
CAUTION
Check to see that the set screws are wrench tight on the locking collars.
PIN A - 1/2" Dia.
PIN B - 3/8" Dia.
Page 47