Table of Contents
Advertisement
BASKET ALIGNMENT
INSTRUCTIONS
CAUTION
Basket Alignment Instructions
Step 1
Loosen both eccentric locking collars on the two basket
bearings (flange and pillow block types). Loosen the set
screws and turn clockwise. If necessary, use a punch and
mallet, striking the punch hole in a clockwise direction to
break it loose.
Step 2
Loosen the four side bolts, "1, 2, 3, 4" on the basket bearing
bracket (see FIGURE 3). Loosen the two adjusting bolts and
locknuts "5, 6" inside the bracket. And loosen the bolts "7" on
the pillow block bearing.
Step 3
Place one "A" and two "B" diameter pins inside the drying
compartment between the rim of the basket opening and the
rim of the door opening in the positions shown in FIGURES 1&2.
Check the two "B" pins for equal clearance.
NOTE: Push the basket toward the rear.
Step 4
With the pins in position, lock the collar nearest the rear wall
of the dryer on the shaft by striking the punch hole in a
counterclockwise direction. Tighten the set screw.
Step 5
Tighten the side bolts "1, 2, 3, 4" in numerical order. Tighten
the bolts "7" on the pillow block bearing. And tighten the bolts
"5" and locknuts "6".
Step 6
Remove the aligning pins and if alignment is okay, then tighten
the collar on the pillow block bearing the same as in Step 4.
CAUTION
Check to see that the set screws are wrench tight on the locking
collars.
Page 34
Advertisement
Table of Contents
