Operating Instructions- Single Timer Models - Continental Girbau L36USS36G Owner's Manual

OPERATING
INSTRUCTIONS—
SINGLE TIMER
MODELS
IMPORTANT
Operating Instructions—Single Timer Models
Step 1. After loading the dryer tumbler with the washed clothes
load, proceed to close the loading door.
Step 2. Turn timer knob to the desired drying time.
Step 3. Turn Temperature Fabric Selector to desired setting.
"LOW" is for delicate, sheer, and easy dry fabrics 130°-
140°F exhaust temperature.
"MEDIUM" is for synthetics and permanent press fabrics
155°-165°F exhaust temperature.
"HIGH" is for cottons, linens and heavy fabrics 170°-
180°F exhaust temperature.
Step 4. Then "ON/OFF" toggle switch to "ON" and press
"START" button, holding about 2 seconds, until dryer is
running.
(To shut the dryer off at any time during the cycles, switch
the "ON/OFF" switch to "OFF".)
Step 5. 1) The fan motor and basket will be energized and revolve.
2) The heat source will be energized (gas burners will
operate).
3) The heated air will mix with the wet clothes and
evaporate the moisture from the garments.
4) The thermostats will operate at a safe temperature.
5) The heat will shut off and the cooling cycle will begin
(motor will operate only to cool the clothes load for desired
handling temperature).
6) The light will stay on until the therm-o-cool thermostat
cools below 135°F before the contacts open to shut off
dryer.
IMPORTANT
If tumbler door is opened during the drying cycle, the fan and heat
will shut off. Press "START" button to resume cycle.
This dryer is designed for a capacity maximum load. Overloading
it will result in longer drying time and damp spots on some of the
load.
Maximum operating efficiency depends on proper air flow. The
lint screen must be kept clean daily to insure proper circulation
of air throughout the dryer.
Page 33