Continental Girbau L36USS36G Owner's Manual page 48

BASKET ALIGNMENT—
DOUBLE MOTOR
MODEL
Basket Alignment—Double Motor Model
Step 1 Loosen the 4 gear reducer mounting bolts "1, 2, 3, &
4" on rear of dryer, and 2 adjusting bolts "5", on
gear reducer housing. (figure 3)
Step 2 Place one "A" and two "B" diameter pins inside the
drying compartment between the rim of the basket
opening and the rim of the door opening, in the
positions shown in figure 1 and figure 2. Check the
two "B" pins for equal clearance.
Step 3 With the pins in position, tighten the two "5" bolts
until flush against back of dryer. Retighten gear
reducer mounting bolts in the numerical order
indicated in figure 3. Tighten lock nuts "6" to secure
bolts "5" in position. Then remove pins.
Step 4 Check the space between basket and door opening
at "A" pin and "B" pin positions (figure 2). If the
gap is not approximately the same on both sides; repeat
Steps 1, 2, & 3.
NOTE
Use short sections of round steel rod for pins, or drill bits
may be used in place of round rod.
Page 48