Air Switch Adjustment - Continental Girbau L36USS36G Owner's Manual

AIR SWITCH
ADJUSTMENT
Air Switch Adjustment (with Illustration)
1. Shut off current; disconnect leads and remove air switch.
2. Lay air switch assembly on flat surface. Adjust air blade at
"A" (figure 1), so that air blade lays flat and surface "B" is
parallel to the flat surface.
3. Place 3/8" x 5/8" spacer bar or equivalent "C" (figure 2), under air
blade in position shown; hold switch mounting bracket firmly
and adjust switch actuator "D" with needle nose pliers at "E"
by twisting actuator right or left, whichever is needed, so that
switch closes when end of air blade engages bar "C".
4. Maximum opening of air switch must be no greater than 3/4"
(figure 3). Bend tab "F" in or out to maintain this dimension.
5. Reinstall air switch assembly on rear of dryer.
6. Recheck operation of air blade. Switch must close before air
blade engages face of opening and reopen before stop "F"
engages.
Page 50