ZKTeco F18 Quick Start Manual page 9

13 Connect to ZKBioAccess IVS Software
Device Side:
Set ethernet and cloud server parameters refer to chapter 12.
Note: The IP address should be able to communicate with the ZKBioAccess IVS server,
preferably in the same network segment with the server address.
Server address: Set the IP address as of ZKBioAccess IVS server.
Server port: Set the server port as of ZKBioAccess IVS (The default is 8088).
Software Side:
Login to ZKBioAccess IVS software, click System > Communication > Communication
Monitor to set the ADMS service port, as shown in the figure below:
Add Device on the Software
Add the device by searching. The process is as follows:
1) Click Access Control > Device > Search Device to open the Search interface in the
software.
2) Click Search , and it will prompt " Searching......" .
3) After searching, the list and total number of access controllers will be displayed.
8