Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
4
Planning information
The table that follows has a list of additional tools and accessories that may be necessary to
complete installation.
Tool / Accessory
Full-size SD card
Small tool (2-3mm in
diameter)
Ground screw
Torx wrench
Fiber optic cable
SFP module
Copper power wire
Belden cable or
similar (with twisted
pairs and a foil shield
with a drain wire)
Bosch Security Systems
Purpose
Record video.
Install an SD card.
Complete the Earth-ground connection on
a pendant arm mount.
Install the ground screw on a pendant arm
mount.
Transmit video and data over an extended
range.
Connect a fiber optic cable to the fiber
port on the pendant arm mount or on the
pipe mount (-F models only).
Must use 1Gbps SFP modules.
The fiber used must be compatible with
the SFP modules in mode (single-mode or
multi-mode), wavelengths (850nm or
1310nm) and termination (duplex LC).
The SFP modules used at both the camera/
mount end and at the head-end media
converter must be compatible, if not the
same exact brand and part number.
Notes:
–
SFP manufacturer is responsible for
reaching the distance claimed for
module.
–
SFP modules must meet the following
temperature specifications that occur
inside the AUTODOME 7100i mount:
+85°C (+185°F) case temp.
Make connections for 24VAC +/-
10%/36VDC. +/- 10%
Make connections for audio and/or alarm
inputs/outputs.
Installation Manual
Planning information | en
Available from Bosch?
Yes (SD-064G, SD-128G,
or SD-256G)
No
No
No
No
No
No
No
2023-02 | V01 |
15
Advertisement
Table of Contents
