Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
1.
2.
3.
Note: Add a tie wrap between the Ethernet cable and 24VAC +/- 10%/36VDC +/- 10% wires to
prevent the black plastic hook pressing the sun shield.
If you connect fiber to the camera, then connect only 24VAC +/- 10% or 36VDC +/- 10% power
input to the camera. Do not connect PoE.
For audio and/or alarm inputs/outputs (I/O):
1.
2.
Bosch Security Systems
To make a watertight seal, wrap PTFE tape (user-supplied) four times around the threads
at the end of the mount.
1.5"NPT
PIPE
1
2
Put the appropriate cables for power, video, alarms, and audio through one of the access
holes in the wall mounting plate. Note: Use of proper grommets is needed, to guarantee
IP66.
Make the appropriate connections for PoE, 24VAC +/- 10%/36VDC +/- 10%, alarms, audio.
On the mount on the camera side, connect the drain wire of the Belden cable (or similar
cable) to chassis ground and grounded metal box.
Connect the other end of the drain wire to a grounded metal box that supports
electrically grounded conduit.
Installation Manual
Installing a pipe mount | en
2023-02 | V01 |
29
Advertisement
Table of Contents
