Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
2
Unpacking
–
–
–
–
–
Notice!
i
Risk of damage to the camera
Do not change the camera orientation while the camera is still in the box. The camera head
must be free to rotate.
2.1
Parts List
Quantity
1
1
1
4
2.2
Tools Required
The table that follows is a list of additional products, sold separately by Bosch or other
manufacturers, necessary to install AUTODOME cameras.
Quantity Product
1
---
--
--
4
1
1
Bosch Security Systems
This equipment should be unpacked and handled with care. Check the exterior of the
packaging for visible damage. If an item appears to have been damaged in shipment,
notify the shipper immediately.
Verify that all the parts listed in the Parts List below are included. If any items are
missing, notify your Sales or Customer Service Representative from Bosch Security
Systems.
Do not use this product if any component appears to be damaged. Please contact Bosch
Security Systems in the event of damaged goods.
The original packing carton (if undamaged) is the safest container in which to transport
the unit and must be used if returning the unit for service. Save it for possible future use.
To protect the PCBA on the mount against ESD, do not remove the anti-static foam
covering the PCBA until after you install the mount.
Component
AUTODOME 7100i │ AUTODOME 7100i IR camera
Quick Installation Guide
Safety instructions
MAC address labels
SD card
Watertight, grounded metal
conduit
UL-listed liquid-tight strain reliefs
Weatherproof sealant (for
example, PTFE thread seal tape)
Studs, stainless steel, corrosion-
resistant
Hex wrench
Torque wrench with torque range
of 10-12 Nm (90-105 in.-lb)
Size
Full-sized SD card (user-supplied)
20 mm (0.75 in.)
6.4 mm (0.25 in.)
to 8 mm (5/16 in.)
5 mm
Installation Manual
Unpacking | en
Part Number
(user-supplied)
(user-supplied)
(user-supplied)
(user-supplied)
(user-supplied)
(user-supplied)
2023-02 | V01 |
13
Advertisement
Table of Contents
