Table of Contents
Advertisement
Preparing the Receiver
1
Insert batteries into the remote
control (page 6).
2
Assemble the calibration mic
stand (page 6).
3
Place the mic stand at your
listening position and set the
calibration microphone on the
mic stand.
Adjust the position of the mic stand so
that the calibration microphone is level
with your ears.
Note
• Fully insert the plug of the calibration
microphone into the CALIBRATION MIC
jack. If the calibration microphone is not
firmly connected, it may not be possible to
measure correctly.
• Install the calibration microphone
horizontally so that L (left) and R (right) are at
the same height.
Calibration microphone
(supplied)
4
Connect the AC power cord
(mains lead) to a wall outlet.
Before connecting the AC power
cord (mains lead), be sure to make
connections for speakers and the other
devices.
"HELLO" appears on the display panel
and then switches to "PLEASEWAIT."
You cannot turn on the receiver until the
"PLEASEWAIT" display disappears.
PLEASEWAIT
HELLO
41
EN
Advertisement
Table of Contents
