Preparing The Receiver; Connecting The Ac Power Cord (Mains Lead); Turning On The Receiver; Setting Up The Receiver Using The Easy Setup - Sony STR-DN840 Operating Instructions Manual

Preparing the Receiver

Connecting the AC
power cord (mains lead)
Connect the AC power cord (mains lead) to
a wall outlet.
AC power cord (mains lead)

Turning on the receiver

?/1
Press ?/1 (on/standby) to turn on the
receiver.
32
GB
To the wall outlet
You can also turn on the receiver using
button on the remote control. When you
turn off the receiver, press
"STANDBY" flashes on the display panel.
Do not disconnect the AC power cord
(mains lead) while "STANDBY" is
flashing. This may cause a malfunction.
Setting up the receiver
using the Easy Setup
You can set the basic settings of the
receiver easily by operating the receiver in
accordance with the instructions on the TV
screen.
Switch the input of the TV to the input
which the receiver is connected.
When you turn on the receiver for the first
time or after the receiver is initialized, the
Easy Setup screen appears on the TV
screen. Follow the on-screen instructions to
set up the receiver.
You can set up the following functions
using the Easy Setup.
– Language
– Speaker Settings
– Network Settings
Notes on Speaker
Settings (Auto
Calibration)
This receiver is equipped with DCAC
(Digital Cinema Auto Calibration) function
which allows you to perform automatic
calibration as follows:
• Check the connection between each
speaker and the receiver.
• Adjust the speaker level.
• Measure the distance of each speaker
from your seating position.
• Measure the speaker size.
• Measure the frequency characteristics
1)
(EQ).
/1
?
/1 again.
?
1)
1)