Table of Contents
Advertisement
Product Guide
1. Connect the mains power cable to the Main Input Unit (refer to
2. Connect the UV800 to the mains power using the 3-pin electrical outlet.
3. Apply power to the UV800 from the wall plug.
4. Switch the Mains Input Unit On.
5. Turn on the UV800 by pressing the
Follow instructions in reverse when shutting down the system.
Ventilation
Free airflow must always be ensured around the ventilation grilles.
Extraction
The UV800 does not require extraction for safe operation.
For heat management purposes, the UV800 is supplied with a Ø150 mm spigot (with 4 M4x10
mm supplied fixing screws) which can be attached to enable coupling to a facility extraction
system
Refer to
Refer to
Always ensure a minimum gap of ≥100 mm (4 in) at the rear of the UV800. Refer to
Figure 2 (page
3).
Do not obstructed airflow from the heat exhaust/extraction port. Refer to
(page
3).
Figure 1 (page
iv).
Figure 2 (page
3).
Attachment to an extraction system must be performed by an extraction specialist.
When attachment is made the airflow rate must be regulated to 6.3~6.6 m3/min.
When the UV chamber is in operation, active extraction must be ensured.
Installation, Start-up, and Initialization
button to the left of the display.
Figure 2 (page
3)).
Figure 2
Page 9
Advertisement
Table of Contents
