Installing Your New Device - INVENTOR PSB20060INL User Manual

2. INSTALLING YOUR NEW DEVICE

• Before using the device for the first time, you should read the following tips.
Venting the appliance
To improve the efficiency of the cooling system and to save energy, good ventilation around
the appliance is required to disperse heat. For this reason, sufficient empty space around
the refrigerator is required.
NOTE: A clearance of 50-70 mm from the back of the appliance to the wall, at least 100 mm
from the top, at least 100 mm from the sides to the wall and a clearance at the front to allow
the doors to open to 115° is recommended.
See the diagrams below.
NOTES:
• This device performs correctly in a SN to ST climate class environment. It may not operate
properly if left at a temperature higher or lower than the indicated temperature range for
an extended period of time.
• Place your device in a dry place to avoid moisture damage.
• Keep the device out of direct sunlight, rain, or frost.
• Place the appliance away from heat sources such as stoves, fireplaces, or radiators.
Alignment of the unit
• For proper alignment and air circulation in the lower back of the unit, adjustment of the
lower legs may be required. You can adjust them with your fingers or with a suitable wrench.
• For the doors to close by themselves, give a 10-15 mm tilt to the rear.
8
Climate Class
SN
N
ST
115
83 1
Temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
EN