INVENTOR PSB20060INL User Manual page 23

Problem
A layer of frost occurs
in the compartment
Temperature inside is
too warm
Temperature inside
is too cold
Doors can't be
closed easily
Water drips
on the floor
The light is not working
EN
• Check that the air outlets are not blocked by food and ensure
food is placed within the appliance to allow sufficient ventilation.
Ensure that door is fully closed. To remove the frost, please refer
to the "Cleaning and care" chapter.
• You may have left the doors open too long or too frequently, or
the doors are kept open by some obstacle, or the appliance is
located with insufficient clearance at the sides, back and top.
• Increase the temperature by following the "Display controls"
chapter.
• Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self-close, or if something inside
is preventing the doors from closing.
• The water pan (located at the rear bottom of the cabinet) may
not be properly leveled, or the draining spot under neath the top
of the compressor pot may not be properly positioned to direct
water into this pan, or the water spot is blocked. You may need
to pull the refrigerator away from the wall to check the pan and
spot.
• Check if the refrigerator is power-off for a long time, this may
cause the ice in the bucket to melt into water, and flow to the
floor.
• The LED light may be damaged. To replace LED lights refer to
cleaning and care chapter.
• The control system has disabled the lights due to the door being
kept open too long, close and re-opens the door to reactivate the
lights.
Possible cause & Solution
23