Nortel 5510 Configuration page 62

62 Chapter 1 General System Monitoring Considerations
To make use of these capabilities, open the MLT_LACP screen by selecting
VLAN > MLT/LACP from the menu. This screen opens with the Multilink
Trunks tab selected. On this tab, select the row that represents the MLT to
graph and click the Graph button. The MLT Statistics screen opens. This
screen is illustrated in
MLT Statistics screen
The following sections will describe the informational tabs on this screen
and the type of data each represents. Refer to
69)
Interface tab
The Interface tab provides read-only statistical information about the
selected Multilink Trunk.
To view the Interface tab, follow this procedure:
Step
1
2
Copyright © 2005 - 2007, Nortel Networks
.
"MLT Statistics screen" (page
for the procedure to graph this data.
Action
Open the MLT_LACP screen by selecting VLAN > MLT/LACP from
the menu. This screen opens with the Multilink Trunks tab selected.
On this tab, select the row that represents the MLT to graph and
click the Graph button. The MLT Statistics screen opens with the
Interface tab selected. This screen and tab are illustrated below.
Nortel Ethernet Routing Switch 5500 Series
Configuration - System Monitoring
NN47200-505 03.01 Standard
5.1 27 August 2007
62).
"Creating a graph" (page