Configuring Qos System-Element; Qos System-Element Command; Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

62 Chapter 2 Configuring Quality of Service (QoS) with the CLI
The syntax for the no qos classifier-block command is
no qos classifier-block
Substitute <1-55000> above with the ID of the classifier block to be deleted.
The no qos classifier-block command is executed in the Global
Configuration command mode.
Configuring QoS system-element

qos system-element command

The qos system-elementcommand configures the system classifier
element parameters that may be used in QoS policies.
The syntax for the qos system element command is
qos system-element
| unknown-ucast] [pattern-ip-version <ipv4 | ipv6 | non-ip>]
[pattern-format <tagged | untagged>] [pattern-data
pattern-mask <WORD>] [session-id <1-4294967295>]
"qos system-element parameters" (page 62)
this command.
qos system-element parameters
Parameter
<1-55000>
known-mcast
unknown-mcast
unknown-ucast
pattern-ip-version <ipv4 | ipv6
| non-ip>
pattern-format <tagged |
untagged>
pattern-data <WORD>
session-id <1-4294967295>
Copyright © 2007, Nortel Networks
.
<1-55000>
<1-55000>

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
[known-mcast | unknown-mcast
outlines the parameters for
Description
System classifier element entry id; range is 1
to 55000.
Filter on known multicast destination address.
Filter on unknown multicast destination address.
Filter on unknown unicast destination address.
Specify the IP version of the pattern data mask.
Valid values are: ipv4, ipv6, or non-ip.
Specify the format of the pattern data mask.
Valid values are tagged or untagged.
Byte pattern data to filter on.
ATTENTION
The format of the WORD string is in the
form of XX:XX:XX:....:XX.
Specify the session ID.
03.01 Standard
<WORD>