No Qos Action Command; Configuring Qos Interface Action Extensions; Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

Parameter
set-drop-prec <low-drop
| high-drop>
action-ext <1-55000>
action-ext-name
<WORD>
The qos action command is executed in the Global Configuration
command mode.
Certain options can be restricted based on the policy associated with the specific
action. An action that is referenced in a meter or an installed policy cannot be
deleted.
You can notice unequal drop rates for two similar packet flows which use similar
sized fixed length packets, in case QOS congestion testing are performed on
ERS 4500

no qos action command

The no qos action command deletes QoS action entries.
The syntax for the no qos action command is
no qos action
Substitute <10-55000> above with the ID of the QoS action to be deleted.
The no qos action command is executed in the Global Configuration
command mode.
Configuring QoS Interface Action Extensions
QoS interface action extensions direct the Nortel Ethernet Routing Switch
4500 Series to take specific action on each packet. This section covers
the following CLI commands.
Copyright © 2007, Nortel Networks
.
Configuring QoS Interface Action Extensions 65
Description
Enter the loss-sensitivity value:
• low-drop
•
high-drop
Default is low-drop.
Enter an integer to specify the action extension;
range is 1 to 55000.
Specify a label for the action extension; maximum is
16 alphanumeric characters.
ATTENTION
ATTENTION
<10-55000>

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
03.01 Standard