Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

4
5
QOS_NSNA Classifier fields
Field
Id
Name
Block
EvalPrec
AddrType
DstIpAddr
DstIpPrefixLength
SrcIpAddr
SrcIpPrefixLength
Dscp
Protocol/NextHeader
DstL4PortMin
Copyright © 2007, Nortel Networks
.
Change values in any fields that present default values if you want to
configure specific parameters.
Click Insert.
The information for the classifier appears in the Classifier tab of the
QOS_NSNA dialog box.
Table describes the QOS_NSNA Classifier fields.
Description
Specifies the ID number of the classifier.
Specifies the name of the classifier. All classifiers with the
same name are part of the same filter set. That filter set
has the same name as the classifiers.
Specifies the block name with which the classifier is
associated.
Specifies the evaluation order number of the classifier in
that filter set. Two classifiers in the same filter set cannot
have the same evaluation order. A higher eval order means
a lower precedence for the corresponding policy.
Specifies the type of IP address used by this classifier entry.
Specifies the IP address to match against the destination
IP address of a packet.
Specifies the length of the destination address mask.
Specifies the IP address to match against the source IP
address of a packet.
Specifies the length of the source address mask.
Specifies the value for a DiffServ Codepoint (DSCP) in a
packet.
Specifies the IPv4 protocol value, or the IPv6 next-header
value. Values are the following:
•
1 = ICMP-IPv4
•
2 = IGMP
• 6 = TCP
• 17 = UDP
• 46 = RSVP
•
58 = ICMP-IPv6
Specifies the minimum value for the Layer 4 destination
port number in a packet.

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
Configuring Nortel SNA solution 181
03.01 Standard