Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

64 Chapter 2 Configuring Quality of Service (QoS) with the CLI
Parameter
name <WORD>
drop-action<enable |
disable | deferred-pass>
update-dscp <0-63>
update-1p<0-7>
Copyright © 2007, Nortel Networks
.
Description
Assigns a name to a QoS action with the designated
action ID. Enter the name for the action; maximum is
16 alphanumeric characters
Specifies whether packets are dropped or not:
•
•
•
Default is deferred pass.
If you omit this parameter, the default value
applies.
Specifies whether DSCP value are updated or left
unchanged; unchanged equals ignore. Enter the
6-bit DSCP value; range is 0 to 63.
Default is ignore.
Specifies whether 802.1p priority value are updated
or left unchanged; unchanged equals ignore:
• ieee1p--enter the value you want; range is 0 to 7
• use-egress--uses the egress map to assign value
•
use-tos-prec--uses the type of service
precedence to assign value.
Default is ignore.

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
enable--drop the traffic flow
disable--do not drop the traffic flow
deferred-pass--traffic flow decision deferred to
other installed policies
ATTENTION
03.01 Standard