Table of Contents
Advertisement
OCTEON CN6645-AAP pass 1.2, Core clock: 1100 MHz, IO clock: 800 MHz, DDR clock: 533 MHz (1066
Mhz data rate)
Base DRAM address used by u-boot: 0x4f800000, size: 0x800000
DRAM: 1 GiB
Clearing DRAM...... done
KCS: Reading boot image number
KCS: Reading front SFP settings
KCS: Reading fat pipe settings
KCS: Reading PCIe clock source
KCS: Reading ethaddr
KCS: Reading serial#
KCS: Reading Power throttling
Flash: 128 MiB
PCIe: Port 0 in endpoint mode.
PCIe: Port 1 is unknown, skipping.
PCI console init succeeded, 1 consoles, 1024 bytes each
Net:
Bcm8707: probed
octmgmt0, octmgmt1, octeth0
USB:
USB EHCI 1.00
scanning bus for devices... 1 USB Device(s) found
Type the command 'usb start' to scan for USB storage devices.
autoboot in 5 seconds...
press 'stop' phrase to abort
IPMI watchdog stopped
Kontron T5519#
•Get proper network settings
dhcp
Kontron T5519#
•Update U-Boot
Kontron T5519# tftp ${loadaddr} u-boot-kontron_t5519-0.42.bin
Kontron T5519# bootloaderupdate
Kontron T5519# reset
5.3.8
Embedded Linux update
1 Start system and connect to serial console
2 Connect to bootloader shell by entering the bootloader bootstop phrase 'stop'
3 Get proper network settings
Kontron T5519# dhcp
4 Update Embedded linux to version x.xx. Below is an example (kernel_rootfs is the first bank):
Kontron T5519# tftpboot ${loadaddr} vmlinux.64-kontron_t5519_0.42
Kontron T5519# run kernel_rootfs_update
Kontron T5519# reset
: Image 0
: Front SFP GE
: Port 4-7 = Target PCIe, Port 8-11 = Disable
: external FCLKA
: 00:a0:a5:78:5d:74
: 9009096065
: CORE0:70 CORE1:70 CORE2:70 CORE3:70 CORE4:70
: CORE5:70 CORE6:70 CORE7:70 CORE8:70 CORE9:70
<==== Enter 'stop' now
46
AM4211
www.kontron.com
Advertisement
Table of Contents
