Table of Contents
Advertisement
INTRODUCTION
TYPICAL SPEED CHART
(RPM's NO LOAD)
(Refer to "Typical Speed Chart")
The following represents data collected under lab conditions.
Flow meters were installed on each of the two 3/8-inch ID
heated air lines used to supply the TurboDisk turbine motor.
The airflow through each flow meter was recorded and added
together to obtain the total air flow through the system. The
speed of the disk was monitored through the means of a
PulseTrack system. The air heater was set at 120 degrees
during all data collection.
TYPICAL SPEED CHART - 10 HOLE
ORIFICE PLATE (NO LOAD)
Disk Speed
Supply Air Pressure
(RPM)
5,000
10,000
15,000
20,000
25,000
30,000
35,000
40,000
Disk Speed
Supply Air Pressure
(RPM)
5,000
10,000
13,000
16,000
19,000
22,000
AA-07-02-R3 (01/2023)
6" CONICAL DISK
Air Flow #1
(PSI/BAR)
(SLPM)
6.6 / 6.45
140
10.5 / 6.72
190
18.2 / 1.25
260
27.8 / 1.92
340
40.4 / 2.79
440
56.3 / 3.88
560
76.4 / 5.27
730
103.1 / 7.11
930
9" CONICAL DISK
Air Flow #1
(PSI/BAR)
(SLPM)
11.3 / 0.78
26 / 1.79
39.5 / 2.72
55.4 / 3.82
79.8 / 5.50
102 / 7.03
Return To Contents
Rotational speeds are unloaded and can be expected to
drop 20 to 30% when under a fluid load condition. Heated
turbine air increases efficiency of motor up to 10%. This
chart should be used as a guide ONLY. Speeds will vary
due to rotator wear, tubing size or lengths, etc.
† Never run disk over it's maximum safe operating
speed depending on disk diameter.
† Air heater removes condensation from OD of mo-
tor at high speeds.
Air Flow #2
(SLPM)
100
140
200
260
350
460
610
800
Air Flow #2
(SLPM)
200
140
330
250
430
340
560
460
760
640
930
800
12 / 66
WARNING
!
NOTE
Total Air Flow
Total Air Flow
(SLPM)
(SCFM)
240
330
460
600
790
1,020
1,340
1,730
Total Air Flow
Total Air Flow
(SLPM)
(SCFM)
340
580
770
1,020
1,400
1,730
www.carlisleft.com
EN
8.5
11.7
16.2
21.2
27.9
36.0
47.3
61.1
12.0
20.5
27.2
36.0
49.4
61.1
Advertisement
Table of Contents
