DeWalt XR DCC1018 Original Instructions Manual page 44

EnGLIsH
To Drain Tank (Fig. A, D)

WARNING: Risk of Unsafe Operation. Air tanks contain
high pressure air. Keep face and other body parts away
from outlet of drain. Always wear certified eye protection
with side shields when draining as debris can be kicked up
into face.

WARNING: Risk from noise. Always wear proper hearing
protection during use. Under some conditions and
duration of use, noise from this product may contribute to
hearing loss.
nOTE: All compressed air systems generate condensate that
accumulates in any drain point (e.g., tanks, filter, aftercoolers,
dryers). This condensate contains lubricating oil and/or
substances which may be regulated and must be disposed of in
accordance with local, state, and federal laws and regulations.

WARNING: Risk of Bursting. Water will condense in the air
tank. If not drained, water will corrode and weaken the air
tank causing a risk of air tank rupture.
NOTICE: Risk of Property Damage. Drain water from air
tank may contain oil and rust which can cause stains.
1. Set the On/Off switch 1
2. Remove the battery.
3. Turn the regulator dial
pressure to zero.
4. Remove the air tool or accessory.

WARNING: When loosening the hose coupling from the
quick-connect coupler
must be held by hand in order to avoid injuries caused by
the recoiling hose.
5. Place a suitable container under the drain valve to
catch discharge.
6. Loosen the safety valve nut allowing air to bleed from the
tank until tank pressure is approximately 1.4 bar (20 PSI).
Then fully tighten the safety valve nut.
7. Drain water from air tank by opening drain valve
bottom of tank.
8. Hold the handle 10 and tilt the compressor towards the
drain valve 7 to allow all water to drain out.
9. After the water has been drained, close the drain valve
The air compressor can now be stored.
nOTE: If drain valve is blocked, release all air pressure by
connecting a tool to the airline and operating it until tank
pressure is zero BAR and contact the D
42
to "Off".
6 counterclockwise to set the outlet
9 , the coupling piece of the hose
7
WALT service centre.
e
Storage
Before you store the air compressor, make sure you do the following:
1. Review the Maintenance section on the preceding pages
and perform scheduled maintenance as necessary.
2. Always toggle Auto On/Off Switch to "Off" and remove
battery. Drain water from air tank. See To Drain Tank
under Maintenance.

WARNING: Water will condense in the air tank. If not
drained, water will corrode and weaken the air tank
causing a risk of air tank rupture.
3. Store the air compressor with the tank pressure at zero psi,
in a clean and dry location sheltered away from weather at a
temperature between +5°C and + 45°C.
D
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
C
Lubrication
Your power tool requires no additional lubrication.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

on
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
7 .
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be
performed by a D
D WALT authorized service centre. Always use identical
e
replacement parts.
WALT recommended
e
WALT factory service centre or a
e