Firmware And System Menu; Creating An Edc File - Jetter JetVewMobile 206 User Manual

Jetter AG

7 Firmware and system menu

7.1 Creating an EDC file

User Manual – JetVewMobile 206
This section describes how to load the firmware and system menu into the control
unit. The following options are available:
■ Via USB
■ Via CAN bus
Both require special Accessories
The EDC file contains all the information needed to update the firmware, includ-
ing the system menu.
The EDC file must be generated. Follow these steps:
1. Unpack the corresponding firmware package. This package is provided for
you by Jetter Support (support@jetter.de).
2. Run script edc_make.bat.
ð
3 files are generated, one for each of the available interfaces:
■ 34434445.EDC: Updating the firmware and system menu via USB [} 24]
■ 3443445_EDC_x_x_x_x_.hex:
CAN bus [} 25]
■ 3443445_Emergency.hex: Update firmware and system menu via RS232 (not
supported).
[} 41].
Updating the firmware and system menu via
Firmware and system menu | 7
22 / 44