Transport, Storage And Disposal; Venting The Appliance - Melitta Avanza 600 Series Operating Instructions Manual

Transport, storage and disposal

5. Insert the drip tray without the coffee
grounds container.
6. Place the coffee grounds container
beneath the Cappuccinatore.
The Water display lights up and
»
requests you to remove the water
tank and insert the water filter.
7. Remove the water tank.
8. Empty the water tank.
9. Insert a new filter in the water tank (see
Fig. 19).
10. Fill the water tank.
11. Insert the water tank again.
The Steam display lights up and
»
requests you to open the "valve".
12. Open the "valve".
If the appliance requests you to fill the
water tank during this procedure, close
the "valve" first. Fill the water tank and
afterwards open the "valve".
» The filter is rinsed with water.
» Water flows into the vessel beneath
the Cappuccinatore.
The Steam display lights up and
»
requests you to close the "valve".
13. Close the "valve".
» The filter programme is finished.
» The Filter display goes out.
» The appliance is ready for operation.
Permanently de-registering the water
filter
If you have removed an inserted water
filter and want to continue operating the
appliance without a water filter, deactivate
the water filter on the appliance:
1. Remove the water tank.
2. Empty the water tank.
3. Remove the water filter (see Fig. 19).
4. Fill the water tank.
5. Insert the water tank again.
54
Press the "Service" button for
6.
more than 2 seconds to call up Service
mode 1.
Press the "Service" button
7.
repeatedly until the display for the Filter
function appears.
Press the "Coffee strength" button
8.
repeatedly until no coffee beans are lit.
Press the "Service" button for
9.
more than 2 seconds to save the
setting and exit the service mode.
» The water filter is de-registered.
» The water hardness is reset to the
water hardness that the appliance
had stored prior to inserting a water
filter.
10. Adjust the water hardness if necessary
(see section. 6.3 Setting the water hard-
ness on page 45).
8 Transport, storage and
disposal

8.1 Venting the appliance

We recommend venting the appliance
when it is not used for a long period, prior
to transport and when there is a risk of
frost.
During venting, residual water is removed
from the appliance.
If you put the appliance back into opera-
tion, automatic rinsing is carried out after
switching on and the appliance vented
(see section 3.6 Switching on the appliance
for the first time on page 37).
CAUTION
Outflowing steam and hot steam pipe
Do not reach into the steam that is
ƒ
flowing out.
Do not touch the steam pipe during
ƒ
and immediately after use. Wait until
the steam pipe has cooled down.