Basic Operation; Switching The Appliance On And Off - Melitta Avanza 600 Series Operating Instructions Manual

Basic operation

CAUTION
Hot water and hot steam flowing out of
the pipe
Do not reach into the outflowing hot
ƒ
water.
Do not touch the steam pipe during
ƒ
and immediately after use. Wait until
the steam pipe has cooled down.
Information
ū We recommend pouring away the first
two cups of coffee after initial start-up.
ū If you want to use a water filter, only
insert this after starting up for the first
time.
20
Fig. 6: ON/OFF button
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the Cappucci-
natore.
2. Press the ON/OFF button (20).
The Ready display lights up
»
briefly.
The Water display lights up and
»
requests you to fill the water tank.
3. Open the lid of the water tank and
pull the water tank upwards out of the
appliance by the handle.
4. Rinse out the water tank with clean
water. Fill the water tank with fresh
water.
5. Insert the water tank into the appliance
from above and close the lid.
The Steam display lights up and
»
requests you to open the "valve".
38
6. Open the "valve".
» Hot water first flows out of the Cap-
puccinatore.
7. Once no more water flows
out of the Cappuccinatore, close the
"valve".
» Hot water flows out of the outlet.
» The appliance is vented.
8. Fill coffee beans into the bean con-
tainer (see section 4.3 Filling coffee
beans into the bean container on
page 11).
9. As required, you can now either
a) set the water hardness (see sec-
tion 6.3 Setting the water hardness on
page 45) or
b) screw in a water filter (see sec-
tion 7.6 Using a water filter on
page 52).
4 Basic operation
4.1 Switching the appliance
on and off
Before switching on after starting up the
appliance for the first time, read sec-
tion 3.6 Switching on the appliance for the
first time on page 37.
Information
ū When switched on and off, the appli-
ance performs automatic rinsing.
ū During rinsing, rinsing water is also
conducted into the drip tray.
Switching on the appliance
1. Place a vessel beneath the outlet.
2. Press the "ON/OFF" button (20).
» The appliance heats up and performs
automatic rinsing.
» The appliance is ready for operation.