Running The Descaling Programme - Melitta Avanza 600 Series Operating Instructions Manual

Care and maintenance
4. Empty the drip tray and the coffee
grounds container.
5. Insert the drip tray without the coffee
grounds container.
6. Place the coffee grounds container
beneath the outlet.
» The appliance rinses twice.
» The Clean display flashes
rapidly and requests you to remove
the brewing unit and insert a clean-
ing tablet.
7. Remove the brewing unit. Do not
switch off the appliance.
8. Rinse the brewing unit under running
water (see section 7.3 Cleaning the
brewing unit on page 48).
9. Place a cleaning tablet in the brewing
unit. Insert the brewing unit into the
appliance.
Fig. 18: Placing a cleaning tablet in the
brewing unit.
The second stage of the cleaning
programme starts. Two coffee beans light
up.
» The appliance performs several
rinsing operations.
The Drip tray display lights
»
up and requests you to empty the
drip tray and the coffee grounds
container.
The third stage of the cleaning
programme starts. Three coffee beans light
up.
10. Empty the drip tray and the coffee
grounds container.
11. Insert the drip tray without the coffee
grounds container.
50
The fourth stage of the cleaning
programme starts. The three coffee beans
flash.
12. Place the coffee grounds container
beneath the outlet.
» The appliance performs several
rinsing operations.
The Drip tray display lights
»
up and requests you to empty the
drip tray and the coffee grounds
container.
13. Empty the drip tray and the coffee
grounds container.
14. Insert the drip tray and the coffee
grounds container.
» The cleaning programme is finished.
» The Clean display goes out.
» The appliance is ready for operation.
Information
If the cleaning programme has been
interrupted, e.g. because you uninten-
tionally switched off the appliance, you
must switch the appliance on again and
follow the instructions from step 10. The
appliance is then ready for operation, even
if it has not been completely cleaned.
For complete cleaning, you must run the
cleaning programme from the beginning.
7.5 Running the descaling
programme
The descaling programme is used to
remove limescale deposits in the interior
of the appliance with fully automatic
coffee maker descaling agents.
To avoid damage to the appliance, we
recommend running the descaling pro-
gramme every 3 months or as requested
by the appliance, unless you regularly use
a water filter.
The Descaling display light
requests you to descale the appliance.