Table of Contents
Advertisement
D
Install the side lock on the second
Tools Needed:
section of the door. secure the lock to
the section with (4) 1/4"- 20 x 11/16"
Power Drill
self drilling screws. square the lock
7/16" socket
assembly with the door section and
Driver
align with the square hole in the vertical
track. The side lock should be spaced
approximately 1/8" from the section
edge.
IMPorTANT: sIDE lOCks MusT BE
REMOVED OR MaDE INOPERaTIVE IN
THE uNlOCkED POsITION IF aN
OPERaTOR Is INsTallED ON THE DOOR.
NoTE: after completing this step,
continue with step 10 on page 16.
D
Tools Needed:
Measure and mark the jamb
approximately 48" to 50" (1220 to 1270
Power Drill
mm) from floor on the right or left side of
door. Drill 1/8" pilot hole for No. 6 screw
1/8" Drill Bit
eye. Tie the pull rope to the No. 6 screw
eye and to the bottom bracket as shown.
WArNINg
DO NOT INsTall Pull ROPEs
ON DOORs WITH ElECTRIC
OPERaTORs. CHIlDREN May
BECOME ENTaNGlED IN THE
ROPE CausING sEVERE OR FaTal
INjuRy.
Please Do Not return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Side Lock
NO. 6 sCREW EyE
Pull rope
1/8"
(4) 1/4"- 20 x 11/16"
sElF DRIllING sCREWs
Pull ROPE
Pull ROPE
BOTTOM BRaCkET
33
Advertisement
Table of Contents
