Optional Installation; Inside Lock; Pull Down Rope - Wayne-Dalton 8000 Installation Instructions And Owner's Manual

Optional Installation

Inside Lock

Install the inside lock on the second section of the door. Secure the lock to the section with
(4) 1/4" - 20 x 11/16" self drilling screws. Square the lock assembly with the door section,
and align with the square hole in the vertical track. The inside lock should be spaced ap-
proximately 1/8" away from the section edge.
IMPORTANT: INSIDE LOCK(S) MUST BE REMOVED OR MADE INOPERATIVE IN THE UN-
LOCKED POSITION IF AN OPERATOR IS INSTALLED ON THIS DOOR.
Lock
(Second)
section
Inside
lock
End cap

Pull Down Rope

WARNING
DO NOT INSTALL PULL DOWN ROPE ON DOORS WITH OPERATORS.
CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR
FATAL INJURY.
Measure and mark the jamb approximately 48" to 50" (1220 to 1270 mm) from floor on the
right or left side of jamb. Drill 1/8" pilot hole for no. 6 screw eye. Tie the pull down rope to the
no. 6 screw eye and to the bottom corner bracket, as shown.
No. 6
Screw eye
48" to 50"
From floor
Pull down
rope
Square hole in
vertical track
1/4"-20 x 11/16"
1/8"
Self drilling screws
Typical bottom
corner bracket
Pull down
rope
16