Main Screen And Function-Keys Notes - Xtool PS2 Heavy Duty Manual

PS2 Heavy Duty
1, When the host boot, tap anywhere to access the screen calibration program interface, as shown
below. ▼
2, Please click on the center of the cross calibration of the main screen cursor after
entering into the screen calibration program interface, (cross cursor will turn in the
middle of the screen, upper left, lower left, lower right, upper right corner of the five
points. Each click will move the cross cursor to the next position. more accurate you
click, better the function of calibration will be. the screen will mention you to click on
anywhere to store the current calibration value after five directions are followed by
click,, then the main interface will turn into the boot.) As shown below. ▼
Tip: Typically, the screen is no need to be calibrated in each using time, but it should
be done in the sense of the using of touch‐ screen is inaccurate or its difficult to click
the selected menu. Touch‐screen calibration also can be set on the setting function of
main manu as it is powered
B. main screen and function‐keys notes
4