Koyker FLEXSTOR 1055 Owner's Manual page 24

Engage the "Winders" and "Drive

Wheel" (if needed) valves. Adjust there
speed accordingly to acquire the correct
conveyor operating pressure.
Decrease the winder
and drive wheel speed
to lower the pressure.
Increase the speed to
raise it.
Conveyor Pressure Gage
The conveyor gage operational pressure

should be set at a steady pressure between
2000 and 2500 psi. Watch the pressure
closely during startup until there is a
constant, steady flow of grain.
NOTE: Decrease the rate at which the
machine is moving into the bag to
lower the PSI and increase to raise it.
Check to ensure the top and bottom knife

are cutting the plastic.
NOTE: The bag may not start cutting if there
is more than one layer of plastic
trying to be cut at the same time.
SECTION 4 - OPERATION
4-13
Adjust the height of the Bag Lift Roller.

NOTE: Although the height is not that
critical, there is a spot that seems to
work best. This spot will vary on
each bag and whether or not the
drive wheels are being used.
Ensure the bag is not
"Bubbling" under the Bag
Lift Roller.
Check to ensure the bag is not rolling

under the Bag Lift Roller. If it is, slow
down the wheel drive since it is
overrunning the spool speed.