Http Mode - Ebyte NA611-S User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

Configure the link parameters, the factory default is server mode (TCPS), the default IP (192.168.1.1), and the

port is 8888;

Turn off other advanced modes, the factory default is turned off;

4.3.3. HTTP mode

When using this function, you only need to select and start a trigger request to get the resources responded by the

server. You don't need to care about the complex HTTP protocol layer. You can choose whether to output the HTTP

header. HTTP supports two common request methods: POST and GET;

Request path (HTTP URL): configurable up to 128 bytes;

Request header (HEADER): The maximum configuration is 128 bytes, and the supported data can contain escape

characters such as "\r\n";

When in HTTP mode

HTTP transmission mode: It is divided into POST and GET methods. When the HTTP information is set, the

information in the information area is directly written, and the device will automatically seal the data packet before

uploading to the network.

页

NA611-S & NA611-SA User Manual

第 29

Table of Contents

Na611-sa