Work Pattern; Transmission Mode (Mode 0); Wor Mode (Mode 1) - Ebyte E95M-DTU User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
When station A is received, it can receive all the data under the 0x04 channel to achieve the purpose of listening.


4. work pattern

E95-DTU has three working modes. When there is no harsh low power consumption demand, it is recommended to configure
the radio station as the transparent transmission mode (mode 0);
The default setting of the station is transmission mode (mode 0).
order
class
number
Through
pattern 0 transmission
mode
pattern 1 WOR pattern
Configuration
pattern 2
mode
Note: If no low power requirements, no concern about WOR mode (mode 1).

4.1 Transmission mode (mode 0)

type When the M0 indicator is out, the M1 indicator is out and the station works in mode 0
launch Users can enter the data through the serial port, and the radio station will start the wireless transmission.
The radio wireless reception function is turned on, and it will be output through the serial port TXD pin
receive
after receiving the wireless data.

4.2 WOR Mode (Mode 1)

type When the M0 indicator is on, the M1 indicator is off and the station works in mode 1
When defined as the transmitting side, the wake-up code is automatically added for a certain time before
launch
launch
receive Data can be received normally, and the receiving function is equivalent to mode 0
Copyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd.
M1 M0
Serial port open, wireless open, transparent transmission
light light
(factory default mode), support special command air
goes out goes out
configuration.
light Can be defined as WOR sender and WOR receiver, support
light on
goes out aerial wake up
The user accthe register through the serial port to control the
light
light on working status of the station. The user can configure the station
goes out
through the upper computer configuration software.
E95M-DTU(400SLxx-xxx) User Manual
explanatory note
15