General Mode (Mode 0); Wor Mode (Mode 1) - Ebyte E90-DTU User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
Name
Mode 0 General mode
Mode 1 WOR mode
Configuration
Mode 2
mode
Deep sleep
Mode 3
mode
Note: If no low power requirements, no concern about WOR mode (mode 1).
★
7.1

General Mode (Mode 0)

Type When M 0 = ON and M 1 = ON, the module works in mode 0
send The user can enter the data through the serial port, and the module will initiate the wireless transmission.
The wireless receiving function of the module is turned on, and it is output through the serial port TXD pin after
receive
receiving the wireless data.
7.2

WOR Mode (Mode 1)

Type When M 0 = OFF and M 1 = ON, the module works in mode 1
send When defined as the transmitting side, the wake-up code is automatically added for a certain time before launch
receive Data can be received normally, and the receiving function is equivalent to mode 0
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
M1 M0
Serial port open, wireless open, transparent transmission
ON ON (factory default mode), support special command air
configuration.
Can be defined as WOR sender and WOR receiver, support
ON OFF
aerial wake up
The user accthe register through the serial port to control
OFF ON the working status of the station. The user can configure the
module through the upper computer configuration software.
OFF OFF The station entered hibernation
E90-DTU(900SL33) User Manual
Description
16