Ebyte NA611-S User Manual page 36

Chengdu Ebyte Electronic Technology Co.,Ltd. NA611-S & NA611-SA User Manual
5. Parameter configuration
There are two ways to configure the parameters: serial port-based AT instruction configuration, UDP-based remote
AT configuration, and serial port-based host computer. For detailed operation, see "NA611-S Instruction Manual
Usage"。
5.1. Hardware factory restore
Hardware factory reset: long press the Restore button 5s (after the factory reset, all LED is on until the button is
released), the device is restored to the factory; If you press 1.5S or above, below 5S, the device will restart but will
not restore the factory settings.
5.2. Directive configuration
5.2.1. Serial port AT configuration
When you need to use the serial port AT command to configure the parameters, first send "+++", and send "AT"
within 3s to enter the configuration mode, and the device will close the disconnection reconnection and restart
without data in the configuration mode, and exit AT Restore the disconnected reconnection and dataless restart
configuration after configuration. If the serial port does not receive "AT" or other non-"A T" data after 3s, the
device resumes transmission.
For other directives, refer to "NA611-S Instruction Manual Use".
5.2.2. Network AT configuration
Same as serial port AT instruction, after connecting the link, refer to "NA611-S Instruction Manual Use".
The above bit computer is configured with a network AT header as shown below
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd. 第 36
页