Flow Meters - USC AT500H Operator's Manual

The pump stands are equipped with volumetric flow meters. A flow meter is used
to perform real - time chemical flow adjustments and monitoring without the operator
having to handle the chemical. The flow meter reading will be displayed on the HMI
touch screen and can be set to read in oz / min or ml / min.
Proper calibration of the liquid system is critical to achieve a proper granular / chemical
mixture. For information on pump calibration and flow meter calibration to determine
liquid flow rate, see the Calibration and Operation section.
Emptying the remaining liquid may be done by using the reverse function on the
control panel. This will pump liquid back into the mix tank. Then drain the remaining
liquid into a suitable container. Clean water should be pumped through the calibration
tube and mix tank when finished.
Only you, the operator, can determine the length of time required to
NOTICE completely rinse all chemical residue from the tank and plumbing
system.
Page 22
AT500H TREATER

FLOW METERS

Volumetric Flow Meter
Always dispose of chemical or diluted chemical according to your
local, state, and federal regulations.