Led Indicator; Led Indicator Overview - Graco QUANTM QTC Series Instructions Manual

LED Indicator

LED Indicator

LED Indicator Overview

LED Indicator
Red, solid
Red, flashing
Yellow, solid
Yellow, flashing
Green, solid
Green, flashing
No light (off)
24
Equipment Status
Control knob set at 0 (zero), system
not operating.
Powered on after a power cycle,
control knob may be set above 0
(zero), system not operating.
Motor fault, motor error.
Calibrating. Performing startup
sequence.
Leak sensor alert.
Normal operation.
Normal operation, stalled against
pressure.
System not powered.
Notes
Be aware that the equipment is energized.
To initiate equipment operation, follow Start the
Equipment, page 22.
See Troubleshoot LED Indicator Event Errors,
page 25.
No action. Allow equipment to finish startup
sequence.
Open the fluid drain valve (G) or fluid shutoff
valve (H) to allow the equipment to cycle until
the startup sequence is finished.
See Troubleshoot LED Indicator Event Errors,
page 25.
No action.
Be aware that the equipment is energized.
Special-case action. See Troubleshoot LED
Indicator Event Errors, page 25.
See Troubleshoot LED Indicator Event Errors,
page 25.
3A8947A