Table of Contents
Advertisement
Preparation
1.
Remove the parts as BC board is visible. (Refer to
2.
Set switch 1 of the DIP switch (S3100) on the BC board to ON.
3.
Install the YD board by reversing the steps of removal.
4.
Connect the PC to the monitor with an RS-232C cable.
Kernel data writing procedure
1.
Turn off the monitor.
2.
Turn on the monitor.
3.
Setup BVM_HAB_TOOL.
4.
Select "Image File" in the [File type] field.
5.
On the [Com port] tab window, set the PC's COM port to be used.
6.
Click [Browse] and set the kernel data to be written.
Kernel data: vxWorks_rom.bin
7.
Click [Download].
Start writing.
Note
When a message "all process succeeded" appears, data writing has been completed.
8.
Turn off the monitor.
9.
Disconnect the RC-232C cable.
10. Set switch 1 of the DIP switch (S3100) on the BC board to OFF.
FPGA data writing procedure
1.
Turn off the monitor.
2.
Turn on the monitor.
3.
Setup BVM_HAB_TOOL.
4.
Select "FPGA Config data" in the [File type] field.
5.
On the [Com port] tab window, set the PC's COM port to be used.
BVM-E171
"4-11. OLED Module Assembly and Bezel
Assembly".)
5-13
Advertisement
Table of Contents
