Table of Contents
Advertisement
4-10.
DC Fan
Preparation
1.
Remove the rear cover assembly. (Refer to
2.
Remove the power block. (Refer to
3.
Remove the bottom cabinet assembly. (Refer to
4.
Remove the BA board. (Refer to
Procedure
1.
Remove the two screws, then remove the BA plate assembly.
2.
Open the three clampers.
3.
Disconnect the harness from the relay connector.
4.
Remove the two turn rivets, then remove the DC fan.
5.
Peel the tape.
PSW
3 x 6
Harness
Relay connector
BC board
Note
Install the DC fan carefully paying attention to the label side and the harness position.
6.
Install the removed parts by reversing the steps of removal.
BVM-E171
"4-3. Rear Cover
Assembly".)
"4-4. Power
Block".)
"4-5. Bottom Cabinet
"4-9. BA
Board".)
Clampers
Assembly".)
BA plate assembly
Tape
Upper side
Turn rivets
DC fan
Label side
4-12
Advertisement
Table of Contents
