Roger Technology B70/1DCHP Instructions And Warnings For Installation page 73

STEP MODE.
PARTIAL OPENING
OPENING
CLOSING.
STOP.
Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the remote control
is active. The parameter
Courtesy light in step mode (PP). The output COR is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter
(1)
mand. Example: parameters
•
pressing CHB on the remote control. Press CHB to activate partial opening.
Selecting courtesy light mode
Disabled.
ACTIVE. The light remains lit for the entire duration of the manoeuvre.
From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
When the clock function is active, the gate opens and remains open. Any command signal received is ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is accepted. When
the gate returns to the completely open position, the clock function is reactivated.
Enable safeguarded gate closure/opening
Enabling this parameter ensures that the gate is not left open due to an incorrect and/or accidental command.
This function is NOT enabled if:
• the gate receives a STOP command;
•
the sensitive edge intervenes, detecting an obstacle in the same direction in which the function is enabled. If instead
the sensitive edge detects an obstacle during the movement opposite to the one guaranteed, the function remains
active.
• the number of closure attempts set by parameter
• the acquired position is lost (perform position recovery, see chapter 20).
Disabled. The parameter
Enabled.
After a period of time set with parameter
less of the parameter
Enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period of
time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period of
time set with parameter
is ignored.
(1)
(1)
(1)
(1)
and set:
is not displayed.
, and then closes the gate.
.
.
N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
is ignored.
has been reached;
, the control unit
), and then the gate closes.
-
-
73