Advertisement
STEP 4
Install desktop cross beams.
Fit power adaptor bracket (11).
A
x4
C
5mm
Install (6) & (2)(3), use 5mm allen
key (C) to tighten screw (A).
STEP 5
Install desktop.
Align the frame with pre-drilled holes in desktop at one end of the
F
x10
frame, then expand the length beam and drive shaft to align the
frame with the pre-drilled holes at the other end of the desktop.
C
4mm
G
Install desktop
with screw (F),
use pistol drill
X
to tighten.
STEP 6
Install control panel and control box.
Install control panel (12) and
control box (14) with screw (F),
use pistol drill to tighten.
F
x4
11
Tighten screws on supporting
beam with 4mm allen key (C).
Tighten drive shaft
with wrench (G).
C
X
G
Overhang (X) distance
must not exceed 200mm.
STEP 7
Install drive shaft cover plate.
E
x4
D
2.5mm
2.5mm
Install (8), use 2.5mm allen key (D)
to tighten the screws (E).
STEP 9
Connect all the cables to the power adaptor (7).
C
G
STEP 8
Install power adaptor.
Attach power adaptor (7) into power
adaptor bracket (11) and secure
cables using cable ties (10).
Switch
Control
Cord Port
Panel Port
Motor
Cable Port
Use the cable ties (10) to fix all the
connection cables to the desk.
C
G
Advertisement
