Initial Operation; Reception Of The Radio Signal - Youshiko YC9333 Quick Start Manual

Initial operation:

 Open the Weather Station battery compartment cover
 Insert 2 x AA batteries observing polarity [ "+" and " –" marks]
 When you insert the batteries, all icons on the LCD will light up for 3 seconds, and
you will hear a beep tone, and then detect indoor temperature & humidity.
 The Weather Station will now start to make a connection to the outdoor remote
sensor. This process lasts for a maximum of 3 minutes and will display by a flashing
reception antenna symbol
 then open the remote Sensor no: 1 , battery compartment cover, push the channel
switch to the "1" position, Insert 2 x AA batteries observing polarity ["+" and "–"
marks], close the battery cover.
 According to the same method, push the channel switch to the "2" or "3" in sensor
no: 2 and 3 and insert batteries in sensors.
 After this all sensors will connect to display unit and it will enter the Radio control
receive mode.

Reception of the Radio signal:

 The clock will automatically search the MSF signal after 3 minutes of any restart or
changing of new fresh batteries. The radio mast icon starts to flash.
 At 1:00 /2:00 / 3:00 AM, the clock automatically carries out the synchronization
procedure with the MSF signal to correct any deviations to the exact time. If this
synchronization attempt is unsuccessful (the radio mast icon disappears from the
display), the system will automatically attempt synchronization at the next full one hour.
This procedure is repeated automatically up to total 5 times.
 To start manual MSF signal reception, press and hold the "-" button for 3 seconds. If
no signals received within 7 minutes, then the MSF signal search stops (the radio mast
icon disappears) and start again at the next full one hour.
 During RC reception，to stop searching radio signal, press the "-" button once.
F.Y.I.:
 A flashing radio mast icon indicates that the MSF signal reception has started
 A continuously displayed radio mast icon indicates that the MSF signal was received
successfully
 We recommend the product be placed at a minimum distance of 2.5 meters (8.2Feet)
to all sources of interference, such as televisions or computer monitors
power adapter.
in the "OUTDOOR" display area on the receiver.
or switching