Reviewing Results - 3M Clean-Trace NGi Luminometer User Manual

5.03 Retesting
It is possible to retest a previously failed test point at any time
after remedial action has been taken. Select the correct test point
as shown above and measure.
Note that the measurement screen now displays 'Retest'.
The new result is stored in the 'Retest' area of the screen. This
time the result is a pass.
It is possible to retest the point several times until a pass is
obtained. The screen will only show the first and most recent but
all previous retests are actually stored.
Note: It is possible to exit from a set of results and re-open it at a later time. For example, if not all measurements
were taken at that time or if there is a need to go back into set of results to perform retests, this may require
returning to an unfinished set of results to collect more data.

5.04 Reviewing results

It is possible to review and inspect previous results and to print to
an external 3M printer either individual tests or a series of tests
from one result set in a given sample plan. Before attempting to
print, ensure the printer is connected directly to the 3M™ Clean-
Trace™ NG Luminometer Docking Station with the 3M™ Clean-
Trace™ NGi Luminometer fitted in place inside the docking station.
Ensure the printer is switched on.
From the MAIN MENU use the navigation ( / ) buttons to
▲ ▼
highlight Review Results and press the Select button.
The list of sample plans stored on the 3M™ Clean-Trace™ NGi
Luminometer will be displayed. Use the navigation ( / ) buttons
▲ ▼
to highlight the plan to be reviewed or printed and press Select.