C - Adjusting Force Margins; D - Battery Functions; E - Setting The Pet Mode Position - B&D PanelMax SDO-8V3 Installation Instructions Manual

PanelMax installation instructions

C - Adjusting Force Margins

The Safety Obstruction
automatically during setup. Adjusting this is normally
only necessitated by environmental conditions such
as windy or dusty areas, and areas with extreme
temperature changes.

D - Battery Functions

a. Holding the STOP button for 10secs when running from battery backup will shut the PCB down so as to reduce
battery current consumption to a minimum.
S E T T I N G T H E P E T M O D E P O S I T I O N
b. Holding the STOP button for 4secs when a battery is fitted and running from mains power will cause the controller to
test the battery state to determine if it is disconnected / open circuit, missing, faulty or ready.
When activated, PET mode drives the door to a
tip
preset position from the close position, therefore
allowing a pet or parcel to go under the door.

E - Setting the PET mode position

S T E P O N E
HOLD
Close to
desired position
S T E P T H R E E
Opener will
Press to
ash and
save
beep
S T E P F O U R
Re t controls
cover
Force is calculated
S T E P T W O
Remove controls cover
Press till gear
repeatedly LED lit
+
LED will light up
Proceed to Storing
the transmitter
Code to code a
remote button to
Press
PET Mode
to exit
A D J U S T I N G F O R C E M A R G I N S
S T E P O N E
Remove controls
cover
S T E P T W O
+
Press together
S T E P T H R E E
OR
Press to
Press to
decrease
increase
Light will dim or brighten
S E T T I N G T H E P E T M O D E P O S I T I O N
When activated, PET mode drives the door to a
tip
preset position from the close position, therefore
allowing a pet or parcel to go under the door.
S T E P O N E
HOLD
Close to
desired position
S T E P T H R E E
Opener will
Press to
ash and
save
beep
S T E P F O U R
Re t controls
cover
26
Press till gear LED
repeatedly ashing
+
remote LED is on and
gear LED ashing
S T E P F O U R
Press to save Press to exit
Then re t controls cover
S T E P T W O
Remove controls cover
Press till gear
repeatedly LED lit
+
LED will light up
Proceed to Storing
the transmitter
Code to code a
remote button to
Press
PET Mode
to exit