B - Adjustment Mode Instructions - B&D PanelMax SDO-8V3 Installation Instructions Manual

PanelMax installation instructions

B - Adjustment Mode Instructions

A D J U S T M E N T M O D E I N S T R U C T I O N S
S T E P O N E
Remove controls cover
Press
repeatedly
S T E P T W O
OR
A D J U S T M E N T M O D E I N S T R U C T I O N S
Press to move
through options as
S T E P O N E
per table below
Remove controls cover
S T E P T H R E E
the remote LED is
lit when editing
Press
active
Parameter
repeatedly
MARGIN x1
S T E P T W O
PE AUTO-CLOSE x2
Pressing the MODE button when a parameter is
OR
tip
AUTO-CLOSE x3
being adjusted will load the default value.
LIGHT TIMER x4
Press to move S T E P F I V E
through options as
AUX OUTPUT x5
per table below
OR
S T E P T H R E E
Press to save Press to leave
the remote LED is
unchanged
lit when editing
active
Pressing the MODE button when a parameter is
tip
being adjusted will load the default value.
S T E P F I V E
OR
Press to save Press to leave
unchanged
till gear LED
starts ashing
Observe the number
of ashes to indicate
the parameter.
Press
to enter
parameter
S T E P F O U R
Value options = Indicated by brightness
of main light
OR
till gear LED
Use either button to
1 2 3
starts ashing
scroll through
If no beep is heard, max
1.0A 1.2A 1.4A
or min setting is reached.
OFF 15sec 30sec
Observe the number
of ashes to indicate
OFF 15sec 30sec
the parameter.
30sec 60sec 90sec
Press
to enter
Mimic
Operating MODE is
1sec 30sec
parameter
light
entered after 5 secs,
unless a new
S T E P F O U R
adjustment is started
or saved.
OR
Press to
exit
Use either button to
scroll through
If no beep is heard, max
or min setting is reached.
Operating MODE is
entered after 5 secs,
unless a new
adjustment is started
or saved.
Press to
exit
4 5 6
1.6A 2.0A -
60sec 90sec -
60sec 90sec 120sec
120sec 180sec 240sec
60sec 120sec 180sec
LIGHT TIMER
• Adjusts the time the main light will remain on after
the door is operated or a remote control code set
to the Light remote control function is used.
AUX OUPUT
• Configures how the AUX Output operates. If
configured for Mimic light mode then the AUX
output will activate whenever the main light
output is on.
• All other settings require either a remote control
code set to the AUX function or the Phone App to
be used to activate the output.
• The time settings option indicates how long
the output will remain on when triggered. If the
output is already on, then a 2nd trigger will turn
the output off.
• The toggle On/Off setting does not use a timer
and the output simply changes state on each
trigger..
When parameter
tip
mode is active, if any
button other than MODE is
pressed, then when MODE
is pressed again, operating
mode will be
instead of the NETWORK
adjustment mode.
DEFAULT parameter
tip
(underlined)
240sec 300sec 600sec
25
edit
selected
toggle