PanelMax installation instructions
14.2 Terminal Block
Wired accessory items can be connected to the terminal block J4.
Terminal connections from top down are as follows:
a. +35V (Auxillary)
b. AUX (Auxillary)
c. SB (Safety Beam input, mandatory);
d. GND (Common ground for accessories and Safety Beam);
e. GND (Common ground)
f. OSC (Open/Stop/Close trigger)
14.3 Connecting or Disconnecting Accessories
The opener can hold up to 4 accessories. For example Secure;
• Auto-Lock
• Wireless PE Beams
• Smart Hub
If an Auto-lock and Wireless PE Beams are both installed
tip
ensure that the channels on the base stations on each
device are different. The channel on the base station
can be changed by sliding the switch in either direction
C O N N E C T O R D I S C O N N E C T A C C E S S O R I E S
S T E P O N E
Remove controls cover
Press
till gear
repeatedly
LED lit
S T E P T H R E E
For PE Beams
Alignment Mode is
entered.
Ensure Alignment.
Re-registering is required every time an accessory is removed.
S T E P T W O
till
HOLD for 2 secs
3 beeps
are heard
OFF
Then replace controls cover
15