IF1200 User Manual
14. Arm and Disarm
● Arm means to start the propellers spinning.
● Disarm means to stop the propellers from spinning.
Step
Verify each item on the Preflight Checklist (see the end of this User Manual).
1
Arm the aircraft by bringing the left joystick stick down and towards the center of the
hand controller (see below). The motors start spinning in an idle state.
2
Note: a Jeti DS-12 is shown below. These instructions also apply to the HereLink
hand controllers.
Position Mode: Once the aircraft has landed, hold the throttle down and to the left.
The propellers stop spinning.
1
Autonomous Mode: The aircraft automatically disarms upon landing.
IFT Doc. Num. 102090, Rev. 3.00
Action
Arming
Disarming
End of Procedure
14. Arm and Disarm
Page 32
Need help?
Do you have a question about the IF1200 and is the answer not in the manual?
Questions and answers