Inspired Flight IF1200 User Manual page 15

IF1200 User Manual
Charge the Flight Battery, Continued
Step
Uncap the battery cable and plug it into the Power Interface port on the charger (see
below).
5
Note: The battery cable and Power Interface port on the charger are designed to
prevent incorrect mating of the two.
Once connected, the battery goes through a precharge countdown for 10 seconds,
then begins charging automatically.
6
Note: To skip the precharge countdown, hold the 'Charge' button for 2 seconds.
Cell voltages and battery levels are displayed on the LCD screen. When the battery
7 is fully charged, each cell voltage should be about 4.20 Volts, and the charger will
display 'Fully Charged'.
If you can't wait for the battery to fully charge, power off the charger by pressing the
NOTE 'On/Off' button BEFORE unplugging the battery to avoid an error message being
displayed on the LCD.
IFT Doc. Num. 102090, Rev. 3.00
DO NOT disconnect the battery cable from the charger while the
flight batteries are charging. Doing so may result in electrical
arcing, causing severe burns to the operator.
End of Procedure
Action
7. Battery Charging
Page 12