Juniper PTX10016 Quick Start Manual page 16

PTX10016 Router Quick Start Guide
16
Use the Phillips screwdriver to attach two mounting screws to the right base bracket
3.
at the bottom right side of the chassis frame.
Use the Phillips screwdriver to attach two mounting screws to the latch bracket at
4.
the top left of the chassis frame (see
Figure 13: Attaching Front Panel Brackets
Use the final two mounting screws to attach a latch bracket to the top right of the
5.
chassis frame so there are brackets on all four corners of the front of the chassis.
Lift the front panel and rest it on the two bottom brackets.
6.
Slide the panel back on the bracket glides until it engages on the two ramps.
7.
Tilt the panel toward the chassis until it is vertical with the chassis. The blue release
8.
buttons on the side of the panel clicks into place (see
Figure 13 on page 16).
Figure 14 on page
Copyright © 2018, Juniper Networks, Inc.
17).